It doesn’t seem to be predictable what octave melody notes will be played in - the same note on the piano roll comes out at different octaves from section to section. Plus the notes are not labelled for octave. Finally, changing key for a whole project can cause whole sections of melody to move to a different octave relative to other sections.
- Is there some way to force the pitch of melody notes to be relative to some fixed reference, rather than apparently randomly assigning them an octave?
- Is there some way to unambiguously see what octave a note will play back at? (e.g. this C is C3, this other C is C4?)
- Is there a way to make a key change transpose the project, preserving the relative pitches of melody notes across sections, rather than some melodies jumping to a different octave?
Thanks
2 posts - 2 participants